Good day pros.My manager just noticed and asked me why there is a solid RED light under interface/Port (Where we plug in the cable) at front panel. I have no knowledge at all about Nexus 9300 switch.I need your expert knowledge about this issue.What...
Good day Pros,I got a task from my Management to Refresh/Replace existing old switches to new Cisco Catalyst 9200 Stack wise.I need to know about the Hardware requirement for Stack wise.1. How many power supply for each switch?2. Do I need only on...
Hello Pros,
we have 5 2960x, , with the latest STIG released on last Wednesday. we need to update the NTP authentication to now use SHA-256.
The current IOS is running is C2960X-UNIVERSALK9-M
I was trying to add
(config)#ntp authentication-k...
Hello Pros,There some Cisco CatalystC2960X, some 3560CX switches in my organization. I have been given tasked to implement latest (CISCO IOS XE and Cisco IOS XE Switch NDM) STIGs into these switches. It worked on C9200 switches after I upgraded to...
Hello Pros,
I was trying a Brand new Cisco 9200 Catalyst switch to Latest IOS firmware. I was able to upload the Image successfully. I would see it in the flash: But when I gave command show version it was showing the old Image.
So I was trying to c...
Hello Pavel TarakanovThanks for your response.I think it is STS[cid:image001.png@01DB9330.83A14860]But I am still confused. Weather is it because of Temperature exceeds OR the fan module is not operational. All fans light is green at the back of the ...
@ Flavio Miranda,Sorry, there was typo in my previous message. Much appreciated. Need one more expert advice, what if we buy C9300-48UN. I could not find the specification/difference between 9200 and 9300 switches. You are the expert could you tell ...
