I have valid NX-OS images uploaded on NDFC Version 12.1.3b in Image Management and policies created, however when I go to Devices tab, it doesn't allow me to select any device there as select boxes against all devices are disabled (greyed out).
What'...
I have discovered Brownfield VXLAN NX-OS switches into NDFC Version 12.1.3b and while doing "Recalculate and Deploy", I am getting error "Overlay VNI [2190001] in state [Down]" reported for all leaf switches. This VNI is associated with VLAN1 which i...
I am reviewing bill of material for a Data-Center networking from a senior engineer wherein N9K-C9336C-FX2 is considered as spine for NX-OS mode deployment, however my understanding is that N9K-C9336C-FX2 is a leaf switch so looking for opinion here,...
This is about VMware ESX (.ova) based deployment with 3 Data Nodes and 3 App Nodes. Nexus Dashboard v2.1(2d), Fabric Controller v12.0.2f.
I am trying to upgrade image using Nexus Dashboard Fabric Controller but it keeps failing with below error: an...
I have not seen this error but I guess it could be related to cisco-ndfc-dcnm-poap-mgmt-http-ssh service.
To verify it, please go to Admin Console> Admin > System Settings and verify under External Service Pool table that assignment for "cisco-ndfc-...
We figured out that the switches were stuck in migration mode in NDFC, they moved to normal mode after successful Recalculate and Deploy and then started showing up under Image management.
NDFC assigns IP to the service "cisco-ndfc-dcnm-poap-mgmt-http-ssh" from External Service Pools, and it is pinging so please check those IP are routable and VM configuration is done properly to allow VLAN for the subnet configured for External Servic...
As the router doesn't appear to be Cisco router so I would recommend you to check with your router vendor for required configuration to achieve routing back to the switch.
