Hello folks, I have an issue with a Cisco 2960 port-security settings. I have enable port-security on the interface f0/3 with shut-down mode, and with a maximum of two MAC addresses. However, when I reach the maximum MAC limit, port-security does not...

Hello, I am trying to check the MAC address for the PO1 and validate that is using the MAC address of the first interface of the port-channel by using Georg Pauwen commands shown above. However, the MAC address of the PO1Switching, Catalyst 2000, LAN...

Hello ladies and gents, This might be an easy question for some of you, but I am still trying to see the benefit of dynamic Etherchannel configuration over static configuration. The amount of line commands are the same as shown in the example below, ...