We are monitoring ingress & egress traffic on a Layer 3 subinterface on Port Channel port in Nexus 7000. The mirror capture is based on filtering with any ip traffic on that port with "dscp=ef"
In the present node config, I dont see any config comma...
Hi,I have a MPLS enabled network with 76XX routers. Just wanted to know if I can provide QinQ type services to customer. I mean to say a Psuedowire carrying multiple vlans of a customer...Customer is giving me a dot1q trunk link to carry to other end...
Hi,I have to carry many few L2 circuits of same customer with a ME6524 as a uPE device. As SVI based EoMPLS is not possible on this device.Can I do the following , (if yes, this solves the same purpose as SVI based EoMPLS).I use vlan 200 for this ...
Hi,My customer is on H-VPLS and many sites are dual homed to different UPEs. I want to avoid any layer 2 loop in this switched HVPLS network. As the same set of MAC can be learned by two different UPEs.Has anyone implemented STP in HVPLS domain in MP...
Hi,1. Can we have a pseudowire (AToM) binded to a VRF ( L3MPLS instance) on one MPLS router?2. Can we have VPLS and VRF talking to each other, without using other router..?ALU, JUniper can do it..Rgds,Gaurav Prakash
Thx,I am facing one problem..If I have 6704 line on PE1 on one side (customer facing) & 6724 on other side (customer facing ) on PE 2. As soon as I configure Xconnect on both side, the port goes down..Although it gives error messgae "UDLD err disab...
Thx, just to clarify..my setup isCE1----PE1---mpls---PE2----CE2PE1/2 are mpls PEs. CE1/2 are L2 swicthes.CE1 has Dot1Q trunk link ,with all vlans allowed, and interfaces Xconnect port of PE1. So Port based Xconnect.Similarly, switch trunk dot1q inter...
Thx,But I need to keep the VC ID of the PWs same ( as they belong to same VPLS domain & same customer ), as there are multiple cirucits coming to this uPE, the only way I can do it to make the switchports mode access , and map it with same vlan id ( ...
Thx,The doc says that we can do BPDU forwarding only for one VPLS.. so it means this is only possible for just one VPLS on the two NPEs.I have attached my diagram.Thx,Gaurav Prakash