About vasrc

vasrc · 05-20-2015

Not sure this is possible....Two SG200's with a common Enet line between them on Port 25 (Trunk).LAN is 192.168.1.x, with multiple devices ported into each switch.Because a Ubiquity AirMax is in one building and the 1921 router is in another, I'd ra...

vasrc · 05-22-2015

I was hoping the thread would just die and I wouldn't have to admit that I had the Cat6 cable plugged into the wrong port :)My original config worked fine once I had the cabling fixed..Thanks for all the responses.Z

vasrc · 05-20-2015

The AirMax isn't setup for VLAN that I know of. It does DHCP, but it's currently configured to give me a static IP.My original intent was to just have the devices (AirMax, Router) connect to the Port 5's, and not need VLAN, just the switches. Not sur...

vasrc · 05-20-2015

MUCH better, thanks.I'm assuming I can replace switch Port 5 for Port 1 shown on the example going to the router.On the port (5) going to the AirMax, I can only seem to configure it for 99UP. Can't get rid of the PVID. On the router config, since it'...

vasrc · 05-20-2015

Thanks for the response.Not 100% clear on the ports and configurations.Here's the way it's currently configured.1921 Router (GE0/1) -> SG200#1 Port 5 -> SG200#1 Port 25 (trunk) ----> SG200#2 Port 25 (trunk) -> SG200#2 Port 5 -> AirMax dishLeaving the...

Member Since	‎03-10-2007 04:23 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	6

User Statistics

User Activity

Basic VLAN config between two SG200 switches

I was hoping the thread would

The AirMax isn't setup for

MUCH better, thanks.I'm

Thanks for the response.Not