About rhuang8x8

rhuang8x8 · 03-23-2011

Hi, I have this Alert-Info header in my INVITEAlert-Info: <http://x>;info=alert-autoanswerfor Intercom, paging.This works fine with Linksys SPA2102 DTA.But SPA50x didn't automatically answer the call.I have Paging Serv enable under phone tab.What els...

rhuang8x8 · 03-23-2011

I did a factory reset and then configure my SIP account.Here is my connected key listhold|1;endcall|2;conf|3;xfer|4;toggle;bxfer;confLx;xferLx;park;phold;flashI believe it's the default value, because I never touched it.However, it's not showing park...

rhuang8x8 · 03-28-2011

Hi, I have figured it out from another thread. http://homecommunity.cisco.com/t5/VoIP-Phones/SPA942-auto-answer-page-intercom-beeping-loudly/td-p/215064I putCall-Info: ;answer-after=0and it works.Thanks for your help.

rhuang8x8 · 03-28-2011

I solved the problem by defining a key with call park star code, by default it's *38. Thanks for your help.

rhuang8x8 · 03-24-2011

Hi, PatrickThanks for your reply. I tried with speed dial programmable key as the document mentioned.When I push the PSK, it'll send a REFER, This more like a blink transfer, which at the moment cannot meet my requirment, because I want to announce w...

Member Since	‎03-23-2011 07:27 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	5

User Statistics

User Activity

SIP incoming paging for SPA50X. What's the header format?

No call park key in SPA504G 7.4.8 firmware.

Re: SIP incoming paging for SPA50X. What's the header format?

Re: No call park key in SPA504G 7.4.8 firmware.

Re: No call park key in SPA504G 7.4.8 firmware.