About razorbakill

razorbakill · 01-26-2017

I have a Ubiquity Pico Station M2 in bridge mode basically acting as a wireless card to the device that is connected to it with a patch cable. Both the Pico Station and the device connected to it are set for DHCP. In one building I have some old stan...

razorbakill · 05-09-2016

I have the CSR1000v setup and configured in AWS with what I thought should work. From the router I can ping google DNS of 8.8.8.8, with a simple command of "ping 8.8.8.8". But if I try to ping 8.8.8.8 form the inside interface address using the "ping...

razorbakill · 04-30-2016

We've setup 2 Cisco CSR 1000v AMI routers with the security package within our VPC. ( subscription license) We would like to have VPN remote access to this VPC using the CSR 1000v routers so our end users can connect to this VPC from any internet co...

razorbakill · 03-21-2015

Hello, I've setup a ASA5505 with basic license running version 8.2 using all 3 interfaces, outside, inside, and the dmz. All is working as it should with the inside and dmz interfaces being able to access the outside and get to the internet.The issue...

razorbakill · 11-27-2012

We are looking to upupgrade from our standalone 1130 series AP's to a Cisco 2504 wireless lan controller and the Cisco LWAPP 2600 series AP's. Currently we have the 1130 AP's connected to a 10/100 3560 POE switch. We also have a 2960 10\100\1000 non-...

razorbakill · 02-02-2017

FYI for others who may run into this problem. The solution that worked for me was to turn on passive client under wlans\your wireless SSID\advance. This allowed my device behind the wireless bridge to get a DHCP address.

razorbakill · 05-06-2016

Thanks Matt, is there a specific service or Smartnet contract associated with the SSL client license (we did purchase 25 SSL user license) or CSR1000v router. I'm assuming without this type of service contract we will be unable to log into Cisco and...

razorbakill · 03-21-2015

That did it! Thanks so much for your for your help Jon. It is greatly appreciated.

razorbakill · 03-21-2015

I was under the impression that the "no forward interface vlan1" on the DMZ interface was so the DMZ could not initiate communication to the inside network. I'm trying to have the inside interface initiate the communication to the DMZ network, which ...

razorbakill · 11-27-2012

Thanks guys for the fast response and information.

Member Since	‎05-15-2007 02:56 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	48
Total Helpful Votes Received	10

User Statistics

User Activity

Trouble getting a DHCP address behind a wireless bridge

Can't ping internet addresses from inside networks on the CSR1000v

Cisco Anyconnect on AMI CSR 1000v

Manage hosts on DMZ from Inside network

Requirements for 11n Wireless

FYI for others who may run

Thanks Matt,

That did it! Thanks so much

I was under the impression

Re: Requirements for 11n Wireless