Have 2 tasks running that are generating log messages:%SYS-3-CPUHOG: Task is running for (2097)msecs, more than (2000)msecs (0/0),process = flash monitor process%SYS-3-CPUHOG: Task is running for (2097)msecs, more than (2000)msecs (8/7),process = SD ...
Just wanted to get others ideas on what commands you run to review the health of a switch. I currently have my own set of commands but would like to get input from others. Thank you.
Have been asked to troubleshoot an issue with web GUI access to a 9200L. Can web browse to the switch and see the GUI interface, issue is the only options available in the GUI are Dashboard and Monitoring. Need to figure out why the Configuration sec...
Hello, working with a Stratix 1783-MS10T which uses Cisco iOS. I am unable to delete 2 snmp-server community lines and one snmp-server host line. Any ideas on what I am missing?
Hi, I'm new to the forums and just obtained my CCENT and have a year left to obtain my CCNP. Here's my situation. I recently acquired a 3845 ISR with IOS c3845-adventerprisek9-m 15.1(3)T2. It also has CME 8.5 and IPS signatures installed but I'm not ...
Please refer to my reply post above for the pertinent configuration data. Adding NAT overload and using DHCP from the modem to the router corrected the problem. Thank you for your response.
