About mzouggagh

mzouggagh · 12-16-2024

does Cisco annonce and of life of FMC version 7.0.1 ? I found announcement for version 7.1 but not for 7.0.x

mzouggagh · 05-15-2024

I have static default route configured in L3out-01 I have multiple OSPF L3outs with 0.0.0.0/0 and both “Export Route Control Subnet” and “Aggregate Export” are enabled I need to filter default route when exporting route from one of the OSPF L3out. ...

mzouggagh · 05-08-2024

By default ACI multipod IPN L3out OSPF external network are E2. I have requirement to change them to type E1. is it possible ? how? I tried to configure route map default export to change E2 to E1 but it did not work.

mzouggagh · 03-12-2024

We have two independent active standby FW-HA in pod 1 and two others FW-HA in pod 2.these FW inspect N-S traffic and E-W traffic. PBR destination in an L3Out was the chosen design option. We configured one L3out to both FW-HA, but when we configure...

mzouggagh · 11-05-2023

Hi, we wrote ansible script to create 200 vlan pool in ACI APIC, but execution is too slow. it take more than one hour to finish the job! With postman it take 2 minutes to create 200 vlan pool. how can we improve ansible time execution?

mzouggagh · 08-27-2024

thanks, I had the same problem and I resolved with document that you provide it.

mzouggagh · 05-17-2024

Hi @Remi-Astruc Thanks, your recommendation is working. we tried an other method: 1) 0.0.0.0/0 with “Export Route Control Subnet” and “Aggregate Export” from L3out EPG 2) created route control profile: - Match routing policy only - deny...

mzouggagh · 05-16-2024

Hi @Remi-Astruc , Nice to meet you too. so from l3out where I want to filter 0.0.0.0/0:1) I delete 0.0.0.0/0 with “Export Route Control Subnet” and “Aggregate Export” from L3out EPG2) create default-export route map with 2 seq, 1 matching 0.0.0.0/1...

mzouggagh · 11-06-2023

Thank you @Torbjørn adding async 60 and pool 0 to the script reduced time execution to about 4 minutes the drawback of this method is the result display all tasks in changed state

mzouggagh · 11-05-2023

yes for config file #ansible --versionansible [core 2.14.4]config file = None

Member Since	‎07-19-2017 12:03 AM
Date Last Visited	‎12-29-2024 07:14 AM
Posts	24
Total Helpful Votes Received	2

User Statistics

User Activity

FMC version 7.0.1 eol

filter default route

IPN change OSPF external E2 network

configure independent active standby FW in ACI multipod

ansible slow execution

Re: I have verified that we do

Re: filter default route

Re: filter default route

Re: ansible slow execution

Re: ansible slow execution