Great app...but i can't login on the ipad2. I get a "Server Error" - "The last action was not completed successfully" a few seconds after entering my user/pass.Any ideas why this is?Thanks,Stuart

Hi Martin,You've got a good config from what i can see. Couple of things i notice is that you've got quite a selection of transform sets. I personally have not configured any Windows clients without the Cisco VPN clients (IPSec or SSL), so not sure ...

Hi Jacob,I see your point, since i heavily scrubbed the config, you are not seeing the full picture. It was easier/quicker for me to remove some of my group policies entirely as they included sensitive data that i am not prepared to share with anyone...

Martin,Just realised the outside interface ip's on each device are confusing when i scrubbed - to clarify, they ARE in the same subnet.Good luckStuart

Hi Martin,I do apologise for the delay, its been hectic at work with a new VoIP telephone system being installed and other work...sometimes being a solo network/system admin can take its toll!I've pasted the configs below- they are heavily scrubbed,...