Hi!
I want to automate the configuration of vlans across a network based on Catalyst 9300 and Nexus 9XXX switches. I have enabled restconf on all the switches and I am able to look at the configuration. I have developed a python script for the Nexu...
When doing agent to agent or agent to queue transfers the customer ID (customer input and stored in a ECC variable) is not transfered to the second agent or queue. This appears to be due to the network VRU in the PG Explorere being configured to the...
Hi!We have implemented a tcl script that plays an announcement from the router flash. This has been implemented on three different routers all running a software version og 12.4.x. However when I try to implement the same script on a router (2821) ...
Hi!I have configured a software MTP on a Cisco 2801 router with IOS software 12.4(13r)T. Unfortunalty it doesn't want to register with the Call Manager. Here is the configuration:-sccp local FastEthernet0/0sccp ccm 172.31.120.10 identifier 1 versio...
I am using the TabSync plugin for Callmanager 4.2 to try and sync outlook contacts with the personal address book on the phone. The PAB works just fine but the outlook sync program on the pc reports that the user login is invaild. Unable to login w...
Hei Alexei
There are two ways to find what your looking for, the easy way is to configure what your after on a switch and then do a get to the switch using restconf/data/native. This should present you with the whole config and you can use the bit ...
Hei Andrea
Thanks for the info very useful if some what irritating. My purpose was to add a vlan to the configuration and the vlan-oper doesn't allow that as suggested by the name. What is also irritating is that if vlans don't appear in the config...
Hei Andrea
I have found the solution. It's not the url or restconf that's the problem. I tested on another switch and I noticed that vlans over 1005 where displayed in the configuration and the vlan container. Looking at my original switch the s...
Hei Andrea
Thats exactly what I'm looking for however the only real difference I can see between the URL you are using and the one I am using is the port 443, which is the default for https anyway. I was using software 17.3.4 when I posted this but ...
Hi!The url you sent with a little modification works fine on a Catalyst 3650 but not on the 9300 models. I am trying to get the yang suite to work. It's a shame most of the examples for IOS XE are based on the CRS products.Peter
