Hi,
Some guidance / Help please!!!
I have a DNAC appliance running ver 2.2.3.5. It unexpectedly lost power, and when it was brought back online it went to a screen where the last message was "Press Enter for maintenance (or press Control-D to continu...
HI, I'm really hoping there's a simple solution!!! I have a pair of 8510 WLC's in HA. Running 8.5.161.0, I've just upgraded to 8.5.171.0 (current "golden Image') There are 1907 AP's joined most of the time. However, there are 2 issues being experienc...
Hi,
Yes, the maglev console still had commands but i had no idea which to run - I tried booting into Linux recovery mode and that broke everything - I'm re-installing from a flash drive AGAIN. Clearly these UCS servers don't play well with loosing po...
Hi,Thank you for the update.We'll ook into the feasibility of implementing the workaround in the environment and the client must make a choice.What we did see though, was that when we failed over the HA pair to the standby unit the situation did impr...
Hi Kusan,Thanks a million,I specifically upgraded to the version for the 8510 that was selected as the Cisco 'golden image' . My understanding is that, that is considered the most stable at this time, or am I missing something??It's still doing it th...
Hi, So just to clarify - The solution proposed here is that "the version of SW is not stable!" What am i missing here?? I have the same issues on an 8510 controller, running 8.5.161, so any suggestions?? thanks in advance
