We have recently upgraded our MCUs from the 3000 series to the 2 x 5320 ones. We have a lot of endpoints that use ISDN to dial into us and used CISCO Conference Director to rename them to display their location and not the ISDN line number. Director ...
I give a mxp 95 at a far location over a satellite link at 512 k. When I try to establish a call to it from the mcu the max rate the call will establish at is 192k. There is no max bandwidth set on the codec or mcu. Any ideas
I have a MXP 95 in a far location that has registed to the VCS but is saying registration failed on the endpoint. I can ping all round the network fine and make a direct call from a endpoint in my office to the far end endpoint wit...
MorningI have a neighbourhood zone set up betwwen 2 VCS and it is registered. 1 location has 1 MCU and the other has 2. The location with 1 mcu can only make a call to one of the MCUs at the other location and not the other. Also i cant make a c...
Since an upgradge to sofware 4.4 on my MCU, in certain conference one of the partcipants seems out of focus. But when i alter the focus no improvement is seen. Any ideas why this is happening
AmitI have attached the snapshot you requested and the search history logs from the VCS. I hope this helps. I have blank out 2 of the octets as this is a secure network.
Martin, it is a vcs control. It is a point to point network over a satellite with 2 routers and no firewall that only has this vtc CCT running over it. I don't have overview of the network but I will get some more information and post it when I get i...
I can only make a call when I turn of the gatekeeper setting on the end points and dial the other one by its IP address and not its e164 number. Do you no why this would work but when registered to the gatekeeper it seems to stop the call somewhere i...
