IntroductionRelated Information:-Introduction Randy Wu is a senior customer support engineer in the Multiservice Voice team at Cisco in Sydney. He has vast experience and knowledge configuring, troubleshooting, and designing Cisco UBE, gateways, a...
Hi, INHOThanks for your update.This command will block all the mid-call signaling, normally it will used with another command "midcall-signaling passthru media-change" to support fax, video escalation from audio. If you only configure this command, ...
Hi, Nizarafter reviewing the debugs and CUCM trace,1. The a=inactive issue was caused by CUCM, it might be related to the transcoder being used as the MTP resource, please open a CUCM Sip issue TAC ticket to find the root cause, for the workaround,...
Hi, IsraelThanks for your question.I wonder if you refer to SBC interface in ASR platform you mentioned.If it is the case, since ASR 1K is a different infrastructure platform for CUBE function, even most of the command used for enterprise version o...
Hi, NizarPlease provide the following information,1. show tech of the CUBE, 10.200.128.133 is the ip address for transcoder? please provide related component's ip address.2. "debug voip ccapi inout", "debug ccsip message" in one file for good, bad...