Dear All,I have setup ipsec VPN in my C2811 router but when "show crypto isakmp/ipsec sa" shows nothing.Remote end point is an "ASA5520". Does it indicates that the remote ASA5520 not yet configured?Here are my Router configuration:crypto isakmp pol...
Is there anyPhone 7961 solution without implementing "switchport voice" immediately at switch port but at the switch before the switch which is directly connected to the phone?(Please see attached diagram. )
Ricky,If the VPN at ASA got only one configuration for VPN and it is now connecting to another site's VPN router C2811.Is it possible to to configured one more VPN at the router C2811 at third site and "join" the ASA's VPN? Thanks.Lai
Can I achieve by doing this? vlan 10 is our LAN.C2811#ping 10.17.91.190 so 192.168.13.254Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.17.91.190, timeout is 2 seconds:Packet sent with a source address of 192.168.13.254 .....Succe...
I have turned on term monand C2811#debug arp ARP packet debugging is oneemee#*Feb 27 04:33:19.822: IP ARP rep filtered src 192.168.0.120 d4ae.526a.9212, dst 192.168.0.120 0000.0000.0000 wrong cable, interface Vlan10*Feb 27 04:33:20.042: IP ARP rep fi...
Rick, Thank you for your advice.-The secondary IP is configured on WAN interface since ISP provided default gateway is within the secondary IP subnet. And I have provided the administrator of the ASA5520 the Primary IP 202.55.8.yy as the peer. I am t...
