Hi,is it possible to use SSL-VPN (anyconnect) on a Cisco2811 (client -> router) and then using NAT to translate the IP of the client for connecting to the network behind the router?The problem I see is there is no interface to use "ip nat inside" on ...

Is there a problem if I have only one OSPF-area and this area is not area 0? So I have only area 100 but not connected to an area 0?Thx.

Similarly to http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=LAN%2C%20Switching%20and%20Routing&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddd2989I have a Cisco 2811 connected to...

Hi!My configuration consists of two 1711 with WIC-1AM running IOS 12.3(7)XR4. I configured dialer-watch, this works fine. But my problem is no routing-packets (no hello packets) are sent across the dial-Up link. I have tested it with EIGRP and OSPF. ...

My problem is on a fibre-connection (trunk) with dot1q enc. between a C2970 and a C4506. The interface on the 2970 counts rcv-err and runts. The interface on the 4506 counts no errors. The Speed and Duplex is on both interface 1000-FULL.The output of...