About steffenmock

steffenmock · 10-29-2014

Hi, first of all I'm new on Cisco switches. In the past I worked with Moxa industrial ethernets switches, but not that deep in detail. So now I have to install a new network for our laboratory.I have to use three Cisco SG500-52 switches in stacking m...

steffenmock · 11-05-2014

Hi,thanks so far.It is partly working now.I configured all ports as adviced to access, configured the standard gateway of each computer to the switchs IP-Interface and I'm able to connect to my servers,But now the problem is, I'm as well able to conn...

steffenmock · 10-31-2014

Hi,first of all thanks for the replies. With Access configuration on the ports and default gateways on the PCs to its switch IP interface, I'm able to ping all other VLAN IP interfaces. So that's so far even a good result :-)But I'm not able to ping ...

steffenmock · 10-31-2014

Hi Aref, system mode is Router. Okay so to VLAN 2000 is the server allocated. Should I change the port where the server is connected as well to access?I'm not so familiar with access trunk etc. but if I change to access then I'm only able to select o...

steffenmock · 10-30-2014

Dos anyone has an idea?

steffenmock · 10-29-2014

Hi,attached, find the output of show run and show vlan unfortunately show vlan brief was not recognized by the switch. If you look in the files, don't wonder, I had to remove the most VLAN names.I changed the configuration to the following:PC1:192.16...

Member Since	‎10-29-2014 01:03 AM
Date Last Visited	‎08-18-2017 04:02 AM
Posts	6

User Statistics

User Activity

SG500-52 VLAN routing

Hi,thanks so far.It is partly

Hi,first of all thanks for

Hi Aref, system mode is

Dos anyone has an idea?

Hi,attached, find the output