What is the power consumption of below endpoint while in video call, only presentation sharing and standby mode.
C60
SX80
MX300 G1
MX200 G1
MX300 G2
MX200 G2
EX90
Okay, in the packet capture i see the VCS is not sending ACK and idle wait time is 2690secs and the re-transmission starts again.The idle timer shows up after 44min after successful call in the syslogs.
Hi Mohammad,The link you are trying is rescue mode of TCS. The reason its not verifying admin uname & pwd is you might have changed authentication settings in site settings page. If authentication earlier was local and you changed it to Domain or LDA...
Hi Artem,Thanks for the response. The TMS version is 13.2.1 and for MCU I'll check and confirm as I don't have access to the MCU but its MSE 8510. Is there any way we can find in logs that this issue occured cz of packet loss? I have seen this issue...
