Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
FN - 72520 - Some Cisco DNA Center Appliances Shipped Between September 2022 and November 2022 Have Incorrect Firmware Installed - BIOS/Firmware Upgrade Recommended
Cisco 3850: IOS-XE/Firmware Upgrade
(Install Mode)
NOTE:
This procedure is aimed at Cisco 3850 switch ONLY.IOS-XE Bundle Mode is not covered. 9300, 9500 (vanilla & high-performance), ISR 1k, ISR 4k and ASR is not covered. Router(s) & switch(es) r...
NotesA Word from our Sponsors:Introduction:Section 1: General ProcedureSection 2: ROMMON UpgradeSection 3: Cellular Modem Firmware UpgradeSection 4: GOTCHA
Notes
This procedure is aimed at Cisco ISR 1k, ISR 4k and ASR 1k router ONLY.IOS-XE Bundle Mo...
@JRDCisco wrote:Pre-Download the image to all the APs. - I think it does this in batches (16 APs at a time every 60 seconds)
There is a way to "pre-download" the firmware to the AP and does not "stress" the WLC and the "limit" (16 APs at a time every...
What is the exact model of the switch?
I have already RMA-ed 12 x 9300X-48H in a span of 2 years.
I currently have an EFA TAC Case to determine the cause of the failure because I have about 450 x 9300X-48H deployed.
What is the budget for this exercise?
If money is not a problem, then I'd go with a Catalyst 9610 with a Sup-3 supervisor card. For access switch, I'd go with 9350.
NOTE: Still waiting for the 9400-Sup-3 announcement.