wuhao0015
Spotlight
Spotlight
Member since ‎10-24-2013
‎12-10-2024
Awards
1

User Statistics

  • 270 Posts
  • 15 Solutions
  • 47 Helpful votes Given
  • 557 Helpful votes Received
Recent Badges
First Discussion
5 articles
10 Articles
70 Discussion Posts
60 Replies
350 Helpful Vote
40 Discussion Posts
40 Helpful Vote
40 Replies
300 Helpful Vote

User Activity

Ladies and gentlemen, technical experts, there's something going on recently. We won't trouble everyone unless absolutely necessary... Using AnyConnect to dial Ikev2's FlexVPN always fails. The device model is C1117-4P, version 17.7.6, and AnyConnect...
哪位小哥能分享下vWLC的镜像https://software.cisco.com/download/home/284464214/type/280926587/release/8.5.171.0AIR-CTVM-K9-8-5-171-0.aesAIR_CTVM-K9_8_5_171_0.ova先谢喽。。
本帖最后由 wuhao0015 于 2020-11-17 10:46 编辑 最近借了两台APIC-M2的控制器做实验,第一台m2设备设置cimc后挂载apic软件顺利安装成功,第二台设备则使用同样的操作出现了问题,无法安装成功。如下图:然后我又在cimc里面重置了bios,重置了coms,重置了cimc,都安装失败。反复对比第一台m2安装成功的cimc配置,发现设备的tpm已经安装但是未激活,感觉就是这个问题。如下图:第一台安装成功为启用状态:第二台安装未成功为为启用状态:于是我尝试着去开启它...
本帖最后由 wuhao0015 于 2020-9-8 12:26 编辑 CUCM 8.6 内线注册号码为5XX,现在添加了一个外线路由5XXXXXXX,然后拨打内线5XX号码需要等好久才能呼通。请问怎么解决呢??这个是我写的路由。
本帖最后由 wuhao0015 于 2020-4-8 20:18 编辑 各位手头有两个1810W,目前发现5G信号发不出来,在设备上看状态貌似正常。用客户端inssider扫描不到5g,客户端也只能连接到2.4g。使用控制器版本为8.3.150,8.5.161,16.12.3都试过,都发不出5g,想请教各位看下是否是硬件问题?WLC#show ap dot11 5ghz summary AP Name Mac Address Slot...
Community Statistics
Member Since ‎10-24-2013 06:01 AM
Date Last Visited ‎12-10-2024 12:11 AM
Posts 270
Total Helpful Votes Received 557
Helpful Votes From
Awards
Community Spotlight Award
Question Answer
Helpful Votes Given To