Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a contractor doing some work for me and he needs to see a few of my access switches.I set him up with a username with privilege 5 and used a rotary group to allow him direct login to enable mode on a specific port.Problem is when I teste...
Hello,ASA HA failover pair running 9.16482ASDM v. 7.20(2)secure client 5.0 updating to 5.1.10 w/ umbrella modI am rolling out the umbrella mod to secure client for roaming umbrella coverage off net due to an incident that happened recently.I was goin...
Hello,trying to figure out if I can add a module to cisco secure client...specifically the umbrella module.Or do I have to do a whole redeployment with the module added at install?If so, can I do this from my ASA? Just upload a new secure client pack...
Hello,ASA 5516x, v 9.16(4)82 HA pairI'm unfamiliar with rest-api so I'm a little nervous about the unknown...I need to install rest-api to start monitoring and collecting logs (for now) for a new siem we are going to start using.Can't find anywhere t...
Hello,I created a new policy to block all generative AI except a couple sites that I allow.In the policy, I allow by identities and add active directory users so they can visit the sites. One of these users tested it and was able to reach the site no...
Hello,I have a contractor doing some work for me and he needs to see a few of my access switches.I set him up with a username with privilege 5 and used a rotary group to allow him direct login to enable mode on a specific port.Problem is when I teste...
I just went ahead and removed the dual trustpoint from my outside interface, deleted it from identity certs and created a new one using the same valid wildcard cert. my trustpoints look normal now with only a single cert associated to it, but I'm sti...
Good to know. so I installed and enabled rest-api on my active first and then did the standby. Now, entering config mode, my standby is telling me:**** WARNING ****Configuration Replication is NOT performed from Standby unit to Active unit.Configurat...
