I inherited a Cisco 9500 at a remote site that has bypassed the startup config every time it has been rebooted. I have issued the "no system ignore startupconfig" command and wrote the config multiple times but am still having the issue. The issue ...
I have an issue with a Cisco C9500-48Y4C. I have two of them in a Stackwise virtual setup, and on one of the chassis I recently started having an issue where any SFP is insert is not recognized. I don't even get a log message saying that an SFP was...
Has anybody had an issue with 9500's not allowing a route-map be applied for policy routing because verify-availability is configured for the route-map? I'm runing IOS XE Version 16.12.02 with Network Advantage, and have verified that it is the veri...
Hello,
I'm utilizing Trustsec in manual mode with the gcm-encrypt setting for layer 2 point to point encryption on some links to other sites in our network. The issue that I'm running into is that it seems to randomly cause the Windows network pro...
I did not, it is going to be a hardware replacement and it is one of our core devices so we have a spare and are just waiting for failure at this point. We migrated all our links off the affected interfaces and haven't had seen the issue spread at al...
I had this same issue and tried the options, but what fixed it for me was adding the next-server command on the DHCP pool instead of using the ip helper on the SVI. Everything I've always read said to use the ip helper but how I was able to get it t...
I had this same issue and tried the options, but what fixed it for me was adding the next-server command on the DHCP pool instead of using the ip helper on the SVI. Everything I've always read said to use the ip helper but how I was able to get it t...
I had this same issue and tried the options, but what fixed it for me was adding the next-server command on the DHCP pool instead of using the ip helper on the SVI. Everything I've always read said to use the ip helper but how I was able to get it t...
I would check the counters on the source interface compared to the counters on the destination interface. The destination interface output should be the input and output of the source interface combined. That will give you an idea of how much traff...
