About missengineer

missengineer · 07-24-2023

Hi All,I have question about DNA center. I have designed 2 seperate network with same Cisco products for different systems. But location will be same. I mean products will be on the same panel but connected system will be different. Supplier tells to...

missengineer · 07-14-2023

Hello everbody,On site, There is a Relay (like ABB REF615) and they have G.703 port but I can not assign IP to these ports.. They have just a bandwidht. I want to communicate them each other on router with G.703 card. Is it possible? Is there any s...

missengineer · 10-08-2021

Hello, I have problem with tunnel routing. The issue that I am pinging tunnel IPs but cant ping to Loopback IP from Site A to Site B. It is working one way. I check my routing table but network does not seem there.In Site B's router shows tunnel subb...

missengineer · 08-04-2021

Hi everyone, I have a general question about some communication failure because of BSTUN protocol. Actually it is not certain but my opinion. Issue is when I configure BSTUN protocol, this config running for a while but after communication drop. I ...

missengineer · 06-01-2021

Hello, I have a problem about HWIC-3G-HSPA card.Line protocol is becoming always up/down and there is message on screen "Mailbox msg transmit failure".Is there any opinion about failure and how can I solve this issue? I am sharing soma screenshots f...

missengineer · 07-24-2023

Thank you very much Miranda for reply and shared pic.It is clear now that you mean it doesnt matter how many I have different Cisco device and seperate network. We can create site on DNAC for each them. So 1 DNAC is enough.

missengineer · 07-24-2023

Hi Miranda,You mean that I can manage my completely seperate network with 1 NMS system? Just 1 DNA server and software will be enough?Am I right?

missengineer · 07-24-2023

Dear Pieterh.Thank you for links espacially wikipedia Please dont think specific ABB615 relay. It was just for example. I know of course RJ45 is not a only ethernet connection. G703 is also use this connector type. For configuration, if I use G703...

missengineer · 10-11-2021

Hi Georg, I solved it! Thank you. Just change my routing configuration from ip route 10.2.1.0 255.255.255.0 Tunnel0 track 254 to ip route 10.2.1.0 255.255.255.0 Tunnel0 and it started to communicate. Thank you!

missengineer · 10-11-2021

When I write sh ip route x.x.x.x "sh ip route 94.79.93.248Routing entry for 94.79.93.248/32Known via "static", distance 254, metric 0 (connected)Routing Descriptor Blocks:* directly connected, via Cellular0/3/0Route metric is 0, traffic share count i...

Member Since	‎01-14-2018 01:02 PM
Date Last Visited	‎05-16-2024 05:50 PM
Posts	34
Total Helpful Votes Received	10

User Statistics

User Activity

Cisco DNA Center for seperate network

G.703 connection to industrial network

Tunnel Subblock

BSTUN Protocol Issue

HWIC-3G-HSPA UP/DOWN

Re: Cisco DNA Center for seperate network

Re: Cisco DNA Center for seperate network

Re: G.703 connection to industrial network

Re: Tunnel Subblock

Re: Tunnel Subblock