About DanielP211

DanielP211 · 11-15-2023

Hello!Did anybody try to upgrade your OpenSSL on Cisco to 1.0.2zg because of the bug? Or is there another way to solve this? TY and BR

DanielP211 · 04-18-2023

Hello, I have two third-party device connected to one C9500 and I would like to establish MacSec between them. I know by default macsec traffic is forwarded to MKA MAC address 01:80:C2:00:00:03, and that the default ether-type is 0x888e. Cisco enable...

DanielP211 · 10-05-2020

Hello!I'm wondering if it's possible to use the Alarm notification Policy with Cisco ASA? The policy we created works on routers and switches (sends an e-mail on config change) but it doesn't seem to work with Cisco ASA. Is it not supported? Thank yo...

DanielP211 · 12-12-2024

It should work normaly. Please post the config.BR,Daniel

DanielP211 · 12-11-2024

Yes I would stack all the C9300Ls together, and connect to the C9300X with a trunk (over fiber optics).BR

DanielP211 · 12-11-2024

Hello! As far as I know you cannot stack fixed uplink models (C9300L SKUs) with modular uplink models (C9300 and C9300X). The problem is the stacking speed, you even have different stacking cable models STACK-T1 for modular and STACK-T3 for fixed up...

DanielP211 · 12-10-2024

Hello!Which switch is it? Can you see a port going up/down and not finishing the dot1x process?BR

DanielP211 · 12-05-2024

Hello!You need to configure the command:management-access ZONE http X.X.X.0 255.255.255.0 ZONE ssh X.X.X.0 255.255.255.0 ZONE And then connect to the IP in that interface. BR

Member Since	‎04-03-2018 11:56 PM
Date Last Visited
Posts	434
Total Helpful Votes Received	139

User Statistics

User Activity

CSCwh18401 - OpenSSL 1.0.2 < 1.0.2zg

MACSEC passthrough on C9500

Cisco Prime and ASA

Re: Cisco c1200 can support port-channel with 9300 or 3750?

Re: Stacking 9300L & 9300X

Re: Stacking 9300L & 9300X

Re: High CPU Utilization caused by 802.1x

Re: Problem with reaching the active ASA Firepower 1150 through VPN