About Th0rv4l

Th0rv4l · 10-30-2020

I am looking to utilize LDAPS (secure version of ldap tcp 636) for authentication mechanism on Cisco 9300 switch. When users login via HTTPS/SSH they would use their Microsoft AD account to do so. Is this possible? Currently working on solution and d...

Th0rv4l · 06-26-2020

Hello community, I am trying to figure out how to load a third-party certificate onto a Cisco Catalyst 2960-X, 3850, and 9300. I have generated a CSR using OPENSSL and had the CA return the certificate. I have combined the key/cert and transferred th...

Th0rv4l · 05-17-2018

I have a device I want to connect a phone via rj11 to the ATA 190. I want to connect the ATA to a satellite terminal for the sake of passing fax data through. Can this be done without the CUCM?

Th0rv4l · 12-29-2022

what should the server-key be if you are using DTLS? I seem to be missing something.

Th0rv4l · 12-29-2022

Are you using DTLS? If so was the server-key just "radius/dtls" I am experiencing similar issues.i.e.radius server THE_IMPERFECT_SERVERaddress ipv4 1.1.1.1key radius/dtlsdtls ip vrf forwarding JUST_A_VRfdtls ip radius source-interface vlan 4010dtls t...

Th0rv4l · 08-06-2020

Anyone?

Th0rv4l · 07-24-2020

Thank you for your advice.

Th0rv4l · 02-05-2019

I recently read ISE requires a two-way trust between the domains. Does it not support the authentication in a domain where a one-way trust exists? Maybe the book I am reading is outdated and changes have been made? I am referring to the ability of th...

Member Since	‎04-05-2018 09:45 PM
Date Last Visited	‎01-11-2024 07:58 PM
Posts	8

User Statistics

User Activity

Using LDAPS for Management Access to Cisco 9300

How to Load Third-Party Certificate onto Cisco 2960, 3850, 9300

Cisco ATA 190 without CUCM

Re: ISE: Dynamic Authorization Failed

Re: 11213 No response received from Network Access Device after sendin

Re: How to Load Third-Party Certificate onto Cisco 2960, 3850, 9300

Re: Here is what I do. Install

Re: ISE with AD One-Way Trusts