About Andy Mackie

Andy Mackie · 02-17-2020

Hi,We currently have a mix of Cisco switches from 2960s, 2960X and now the 9200L. However we are having issues with our Paxton POE door controllers. The 2960s work with all of our Paxton ControllersThe 2960X up to hardware version 4 work with the Pa...

Andy Mackie · 01-05-2023

We have gone with..a) all new Net2 Controllers we purchase make sure they come with a power supplyb) We install a Netgear Unmanaged POE switch into the cabinets where the controllers go to and connect that back to the Cisco Switchc) Use Cisco Wireles...

Andy Mackie · 01-05-2023

Unfortunately not. It is the Paxton Net2 device that isn't POE compliant and not an issue with the switch.

Andy Mackie · 08-22-2022

The last switch we had working was a 2960X Hardware version 4 with any firmware. After that We've not been able to get any Net2 controller to be powered.

Andy Mackie · 08-17-2022

Paxton admitted to me that it was the Paxton Net2 POE Controller that wasn't fully POE compliant, other devices such as handsets and intercoms seem to be fine.We've given up on finding a solution and now use Netgear POE switches where we have to and ...

Andy Mackie · 01-04-2022

Its actually an issue with the Paxton controllers.. the older Net2 system kit isn't actually fully compliant with POE standards. We've had to put a single Netgear POE switch in each cabinet to power them.

Member Since	‎04-17-2018 08:31 AM
Date Last Visited	‎01-25-2023 01:13 AM
Posts	13
Total Helpful Votes Received	23

User Statistics

User Activity

Cisco 2960X and 9200L POE support for Paxton

Re: Cisco 2960X and 9200L POE support for Paxton

Re: Cisco 2960X and 9200L POE support for Paxton

Re: Cisco 2960X and 9200L POE support for Paxton

Re: Cisco 2960X and 9200L POE support for Paxton

Re: Cisco 2960X and 9200L POE support for Paxton