About sstrollo

sstrollo · 04-23-2019

Hi This isn't actually a question, just a helpful tip in case you run into this. The Problem If you have just upgraded your OS and made a local install of NSO you might be running into issues when setting up netsim devices. You will see something lik...

sstrollo · 12-04-2018

Hi, Sure, you can invoke actions over NETCONF as well. Since the introduction of YANG 1.1 there is a standard RPC to do this, using your example the syntax would be (note that you need the correct namespace or you will get an error message): <act...

sstrollo · 08-30-2018

Hi There currently is no default fallback mechanism for a transaction id for NETCONF devices. (Which is why it says unsupported). As more and more NETCONF devices become available NSO will add something. /Sebastian

sstrollo · 08-30-2018

Hi The result unknown means that NSO doesn't have a record of a transaction id with that devices, and so it doesn't know if it is out of sync or not. Reasons for this can for example be: you have not yet done a sync-from, you have committed a change ...

sstrollo · 04-19-2018

HiYou need root privileges for System Install because System Install installs NSO in directories normally owned by root (e.g. /etc/init.d) if you do not want to install as root you can use "Local Install".(Note this doesn't have anything to do with t...

Member Since	‎04-07-2015 03:28 AM
Date Last Visited	‎11-05-2019 05:16 AM
Posts	5
Total Helpful Votes Received	90

User Statistics

User Activity

Netsim: getting "No supported host key algorithms" when trying to connect

Re: Calling User Defined Actions using Netconf

Re: check-sync returns "unsupported"

Re: Check sync result unknown

Re: NSO System install with non-root user