Hi,Eddie
Thank you for your prompt reply.
For Q1,It's about step 10, if “redundancy switchover” command was issued to try to Failover from active RSP440 (slot 1) to standby RSP880 in (Slot0), will it have any traffic impact if NSR are enabled and ...
Hi,Eddie
I have two questions:
Q.1:
10) Failover from active RSP440 (slot 1) to standby RSP880 in (Slot0)
“redundancy switchover”
Is there any possibility that control/data plane traffic drop during this step with NSR?
Especially, when the fo...