The datasheet for the DN3-HW-APL lists a reduced core count compared to the DN2 version, but it does not mention RAM or disk specs. Does the DN3-HW-APL have reduced specs for the memory and disks as well?
If you don't need the "how and why" you can find complete templates in the summary section at the bottom of this post.The problemCatalyst Center onboarding templates are somewhat limited in functionality. They don’t allow for interactive commands suc...
The release-notes for CML 2.7 beta has been released, but there is no mention of when the regular release will happen. Is there any timeline for when we can expect 2.7 to enter general availability?
I am working on automating lab setup with Terraform and have hit a wall with DNAC-VA configuration. I have figured out how to apply basic configuration to the DNAC-VA using cloud-init on VMware(imitating the launcher). But this leaves something to be...
After quite a lot of troubleshooting I found that the latest IOSvL2 image fails(throws CPUException and resets) when I bring up L3 port-channels with multiple subinterfaces. Where can I report bugs like this?
That is correct. Cat9200 series devices can only be edge devices.Refer to the compatability matrix to see which devices can have which roles: https://www.cisco.com/c/dam/en/us/td/docs/Website/enterprise/catalyst_center_compatibility_matrix/index-sda....
That would be getAllHostObject, same parameters used there. The list of all available operations can be found under the docs in the Github repository
EDIT: Wrote this before I saw the reply above. You're correct!
I'm sorry @fmugambi, I misremembered the usage of getAllNetworkObject in regards to group objects. You should use getAllNetworkGroup there instead. The parameters should be the same so you'll only have to change the operation.