Voice and Conferencing - Small Business

Hi, Since a few days we are facing an big issue with SPA 303 and 504G phones. when you restart the phone it will work for 30 minuts. then the phone will freeze. when you try to call the phone you get the message: temporary unavailable. the only solut...

I've made the following changes to enable use of hook-flash:Voice > Regional > ‘Hook Flash Timer Min’ and ‘---Max’ set to 0.005 and 0.05 respectively.  It seems these values are multiplied by 60 to convert to seconds and the default values (0.1 & 0.9...

Hello, I am looking for some direction on what I should look at next regarding an issue with voicemail on a UC540. Here is the scenario; I have an employee who has an internal extension with a mailbox attached and a DID, all assigned to a 525G2. When...

My existing system is being used with Cisco CME 8.6, Cisco MCS 7825-H3, DTM, IPASand the IP phone model is CP-7821-K9 and  Cisco Unified IP Phone 7942G . In that system now audio conference is not being used. As per CME, it supports 3 way conference....

Hi, Hi have just bought a Cisco SPA 112 and need to configure it for Off-hook dialing.The device should automatic dial a number when user "Off-hook" the phone, it´s a support phone. //Jim  

Good morning everyone,I have a problem and I'm not sure how to solve it. I try to explain.I have a UC540 with severals SPA514G and everything works fine. Now we have added a sip trunk in the UC540 and it also works well but the problemis as follows, ...

Hello, I have a UC540 with severals SPA phones.I just enable a SIP trunk with 6 channels.My phone has four lines and each line support up to 2 calls, then my phone could receive up to 6 calls at maximun.In my incoming  dial plan , I setup a blast gro...

Good Afternoon,Just looking for a bit of advice. I don't really have any experience in this area, but I've been asked to look into it anyway.We have a Cisco UC320 phone system. We are trying to use a dial-in voice-conferencing system that relies on i...

Hallo,I've uploaded, with TFTP, an updated italian dictionary (from cisco) for my SPA504G but the phone after reading and rebooting shows an empty blank screen, without life.I've tried:cisco firmware reset, but the phone doesnt bring up the network i...

Is there an option anywhere in the SPA series of phones to force a reboot every X number of days?

I'm not entirely sure which location/selection this should be in, please move if neciscary.I have been having some trouble for some time with using my phone connected to my modem via the SPA112. Whenever I call a place that has an automated message t...

HeyWe have a UC520 via analogue line.Now we want to switch to a SIP trunk and this works.Incoming and outgoing calls arrive, only when we call out does the number come through as an anonymous to the recipient.He seems to be calling out the number of ...

on a conference phone base model 8831, how many additional "Wireless" mics can be added if any?Note we already have 2 wired mics connected. 

Hi!I am a Cisco SPA232D configured in bridge mode (...I already have a Cisco RV325 that does me the vLans routing work and it interfaces with my ISP's modem).The SPA232D is configured in vLan class 11 (...my native vLan is in class 1). I have a "big"...