Voice and Conferencing - Small Business

Hi guys,I have a cisco SPA502G IP Phone, i have configured a new name under voice register global and also issued the 'create profile' command, but still if you call the extension it displays the old name.Kindly assist.Am using cme vesrion 8.6

Will SPA525G work with Spectrum IP Phone Network?

For the experts on this forum this might be a too easy question: I would like two connect two cisco spa 301 ip phones with one cisco sg300 switch between both. Just to be able to make phone calls from one ip phone to the other, nothing else. Which si...

I use Cisco SPA series phones and I utilize one touch button to park calls and the operator announces the parking lot number the call is parked on before the call is hung up.On the Cisco at least on Asterisk 11 this requires: Keep Referee When REFER ...

Hi,a customer has 4 SPA 303 - 7.5.5 all the same. In one there is this little noise/pitch like an interference, only in one of the four, the other three are4 OK. I included a mp3 file (in spanish) to hear the sound.Any idea, I would really appreciate...

I have about 10 Cisco 514G deskphones from my old provider and I've tried playing around with them however, I've noticed that they are locked down.  I tried a factory reset but when I log in through the web interface I can see that under customisatio...

Hello, Wondering if there is a way to identify missed calls and what line they call into via the missed calls. On our 508Gs this is a feature, and will show the line it's calling into in brackets (example: [E2] if it's on a second line) via the misse...

I have a SPA112. I need to connect a modem and a fax to the device.Both lines should use the same SIP account for outbound, but only one should be used for inbound. In the thousands of parameters in the setup I miss the one to configure that inbound ...

Goodmorning, We have the follow case:We have a hotel with 100 cisco spa 301 phones on a Yeastar PBX local in the network.There are 4 phones they have a problem:- When you pickup the handset the first two seconds are a busy tone then normall.- The red...

I am trying to program a line key on a cisco 508G to dial a Call park to a specific line on a Broadsoft hosted phone system.  I programmed the line key with *865411 but it only dials the *86 none of the numbers after that. 

When I press the login button in the configuration utility additional characters are added to the password, causing the login to fail.I have reset the device by the reset button and using the telephone voice system but to no effect.Anyone got any ide...

Hello, We are using a Cisco UC540. We have Option 3 forward calls to an external number. Does this tie up our internal phone lines? ThanksUC540

Hello all, i have an issue with my Cisco UC540. I have moved over from ISDN trunks to SIP with sipgate.co.uk and i cant make or receive calls on the system using either a 9971 or 7975G. I had it working the other day where it would dial in this forma...

Hey all, new to SIP and can't figure out what I have wrong with my config. I have attached my running cfg as well as output from debug. I am not able to dial in or out of office but all extension to extension calls are fine. Provider had me disable A...