Voice Systems and Accessories - Small Business

Hi all,Don't know if somebody tried it before.One SPA504G, Ext1 configured for using an extension on a foreign PBX, Ext2 configured for using an extension on another foreign PBX.All's working well, by pushing the key i can choose one or the other ext...

I use Callcentric for by business phone. I've been using a Grandstream ATA. A few weeks ago, it seemed to quit working, so I bought a SAP 112.Hooked it up to our Linksys router and then to our Comcast modem/router just as the previous Grandstream had...

I was running 7.5.5 and was having an issue with out-of-band DTMF not working while on the speakerphone. Saw in the release notes for 7.5.6 it was a fixed bug.  So I downloaded the newest release, 7.5.7s and updated.  That fixed that problem.However,...

Hi I have 2 SPA 504G hand-sets that I want to use with BT Cloud Phone but because I didn't buy them from BT they are refusing to give me the configuration details.  I have trawled through various documents and inputted a configuration but I'm getting...

I have some problem with my SPA-504G, the ip phone don´t sent a DHCP discover on the voice vlan, this works fine if i dont enable the vlan taggin and unset te vlan, when i set this parameters the phonenot receive ip automatically, but if i set the ip...

Hi All, I have a setup with CUCM, CUC and CCX are configured in Business Edition 6000. I want to setup Auto Attendant with the below requirements. All incoming calls from PSTN network (configured in Cisco 2921 gw) will land to Auto Attendant Extensio...

Hi all,I have a SPA-921 that suddenly stopped working.When its connected either on the PoE interface or directly to power source, LEDs are blinking in the following pattern:1) mute, headphones and speaker light on, then2) headphones and speaker off, ...

It seems that every line (extension) has own dial plan.Anyway to pick the right line depends on dialed number?For example, I have two totally separated PBX. One has internal numbers starts from "1" and another starts from "2". They are assigned to tw...

Hello,  I have a Linksys SPA921 Ip phone and it will sudenltly not power on.While i connect it with, either PoE or Power Supply, it blinks at the following pattern1 ALL (Microphone, Headset, Speaker)2 Just the microphone3 Speaker and Headsetwithin tw...

Good morning everyone!I'm from Brazil and I currently having many problems to provide a solution for my University's Final Project.Currently I have the following:Softphone/Analog Phone <<< >>> Asterisk <<< >>> SPA3000 <<< >>> PSTN line.I configured a...

Does the SPA122 ATA have an on-board TFTP server?The documentation implies that it does.Page 32 of the Administration Guide describes configuration of theon-board DHCP server, particularly when the value "NONE" is selectedfor the Option 66 parameter:...

Hello,Trying to reload a Cisco UC 520, CUE, only, the CF card went bad, I replaced it.There were no backupsUsing cli, I did a service-module integrated-Service-Engine 0/0 reload and confirm, then service-module integrated-Service-Engine 0/0 sessionco...

Hello, I am wanting to change the 7905's I have over to SIP... I have set up the TFTP server with the appropriate files: CP7905010100SIP030807A.sbinCP7905010100SIP030807A.zuplddefault  (cfg file) The TFTP Server Log shows as follows:Connection receiv...