Hi, I installed a new SPA 3102 connected to an asterisk mini server; the phone and line plugs connect to the existing land line and phone.The device has current firmware, and the one and only ethernet cable plugs into the WAN port - these two steps m...
The spa8000 allows you to setup a trunk of 1 phone number to hunt to all 8 lines. if you add a srp541w which has 4 lines on it how can you hunt to those other 4 lines so youll have a total of 12 lines on a phone system? Thanks
I've searched a lot about it but I've not been able to find a way to "Camp on" a busy line on my SPA504G phones via Asterisk. Is this possible?
Just purchased some spa514G phones and there is no call parking option available as softkey!!!After 5 hours of reading... http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/csbpipp/ip_phones/administration/guide/SPA_500_admin.pdf page 75, I still...
It appears as if you cant change the AA Alternate Greeting remotely.An example would be if a business was closed due to snow and a manager wanted to call in and leave an alternate AA greeting that the office was closed for the day, but staff would be...
Has anybody tried to use the SPA500ds on the 514G? Also when is the SPA500ds going to be available within CCA and QPT?
In configuring the SPA303 it seems that it only supports TWO SIP accounts, even though it is a 3-line phone.I need three lines, each with their own SIP account ("proxy.") It seems that EXT1 and EXT2 have the field to enter the account URL, but oddly,...
Hi,What (if any) plans are there for IPv6 support for the SPA series units to support IPv6 addressing and IPv6 SIP server connectivity?The LAN I manage here is fully IPv6 enabled, and my VoIP service provider is looking to provide IPv6 SIP server con...
In my previous post, I am asking about SIP attacks/scans. Which has left me wondering if we need a dedicated firewall between the UC320W and our internet connection. Given the setup below, do you have recommendations on what firewall I should be re...
I would like to ask you about Caller ID settings.I'm using Cisco SPA3102 as a PSTN gateway with IP-PBX system,and it works well for making and receiving calls through PSTN (in US).However, I couldn't see Caller ID with our IP-PBX system even though S...
Cisco ip phone 7960 uses sccp and sip protocols,I have a Cisco ip phone SPA504G to test,can I test this on the same network where I tested 7960 phones.
I have a Bogen analog phone hooked up to SPA112 which is connected as a SIP device into a shoretel system. The calls completes fine but when the shoretel phone hangs up, the SPA112 plays the CPC tone through the door phone speaker and then does a si...
We recently have unplugged the power and tried to replug in. But now, it will not boot. It flashes some light and turns off completely. We have tried use our second Cisco Spa 525g power, it does the same thing, trying to boot but failed. Please help ...
1st, this is probably the hardest forum to find (on Cisco's support site) that I've ever encountered. Like they're trying to keep it a secret.Not sure WHY they have this under (only) Small Business - but I found it! Not under any forum menus, but b...
I have recorded unavailable, busy & temporary greetings. How do I change the Mailbox greeting to play the temporary instead of the unavailable recording in the UC320W?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: