Hi Guys, I have a UC540 with SIP Trunk porgrammed. I configured "caller ID per Call block code" as "*111" in CCA (Configure-->Telephony->Dial Plan->Outgoing->Caller ID" , then I tried calling outside line from a Cisco SPA500 phone by dialing ...
Hi,I have a problem with outgoing calls to certain destinations.We have UC560 with PRI circuit and extensions range of 4XX.For direct dials telco sends did in four digit format which is 94XX - last for digits of actual phone number.We also use 9 as a...
Anyone using Procurve switches with these UC devices?I tried tagging ports on my procurve for VLAN 10 and 100 but that still didnt work...Anyway I'm running now on an unmanaged switch, but I want it to work on my switch whcih was a stack member.Thank...
HiI have a UC-560 and I want to send automaticaly the CDR for all outgoing call to the FTP server.i have config the UC560 as follows:gw-accounting file
primary ftp 192.168.0.107:21/CDR username CDR password <removed>
acct-template callhistory-detai...
Hello Guys,can i send to an Cisco SPA XXX a check sync with ua-profile?I need to update the prov. link from http://yyyyyyyyy/$MA to http://xxxxxxxxxx/$MAI know i could use an http get /resync with the new path but like to keep it to sip...
I have tried and tried to follow previous instructions on the website but have had no such luck. I am still unable to get the rings and background images to display on my phones menu. I have performed a dir command and I see the images in the flash a...
Hello GuysI have a Cisco UC540 and Im planning to buy a ASA 5505.I would like to register a remote phone (SPA525) to the UC540 but the ssl VPN is going to be establish between the Phone and the ASA. Is this possible without any extra licensing?I have...
I have a configuration with 2 sites. I have UC540 at the primary site, and a UC520 at the secondary site. The VPN is up and passing data traffic as well as voice traffic, i.e. users can dial each other's extensions by using the Inter-site prefix and ...
Hi I have a user on current key system, that when they are paged or extension transfer, they have a push button setting to eauto answer talk or mute. Is this possible on the UC 320
HiMy customer needs to support 3 page zones. 1. page to through phones only2. page to overhead amp'd external page3. page to both through phones and to overhead amp'd external page please advise if anyone knows if UC 320 supports this or if they ...
Hi Members, I have a company which has 2 x PSTN Lines. I setup a Shared line for each of the Trunks, however I want to be able to have it only ring on one extn and flash on the other, but still have the ablity to operate like a key station. So if Use...
Hi all, hope I can get some good advice for this install, here's how it goes...Site A (main) will have a UC560 with approx 70+ usersSite B (branch) will have a UC540 with approx 10+ usersCurrently there is no telephone service at Site B as they piggy...
We have a UC540 and I have been trying to get CallerID blocking on a call-by-call basis. From what I have reviewed online, the "caller-id block code *9" under "telephony-service" should provide my callers the ability to dial "*9" and then the outside...
Hi is there a procedure of how to configure 7916 expansion module on a 7962 phone ? there is no step-by-step procedure on administration guide. can anyone provide a link or point out where to find the configuration procedure ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
