We have new Cisco 8861 phones programmed with voip.ms set up and working, however the DND mode does not turn the BLF indicator red. Is there a setting that needs to be changed to enable this? I've found the following documentation from Cisco, but as ...
Forum Posts
Resolved! Error Programming BLF
We just got Cisco 8861 phones and I am working on setting them up, I can receive and make calls no problem. However when trying to set up the BLF fields I keep getting a flashing or solid amber light. We are using the phones with voip.ms and I have c...
Hello.. I rolled out a bunch of SPA122 for my customers.. A few of them are reporting that they are getting echos on the caller side. Caller is reporting they can hear a delayed echo of there own voice. I've made sure echo cancellation is on and I've...
I have a customer who is using a Spa 122 to connect to our Voip network. On inbound and outbound calls the far end party hears themself in an echo. We have tried adjusting the echo cancellation, Gain, settings for the fxs ports, and adjusting the fir...
I have a SPA504G phone that has stopped working correctly. When I dial out or someone dials in, they cannot hear me, and I cannot hear them. Can you please suggest some possible solutions? Thank you!
How do I change the number of times a phone will ring before voicemail picks up? On the UC320W or the SPA303 phone.Thanks in advance.
Hi,I'm having a problem trying to log in to SPA 122.When resetting to factory, I begin to configure and after one or two reboots, it begins to deny the default password. I tried on one occasion to change the password but the problem persists. Thanks
Hi guys,I'm from Italy. The ATA when I answer the phone change the hook state to off. The phone rings fine but I can hear nothing and I can hang up. Please help me!
I have the SPA525G wired with the computer hooked into the phone for my internet service. I have 1GHz internet, but not getting that speed at my computer. Is the phone limiting my computer to 100Mbs?
I have a Sp112- Recently installed with ddi number via voipdiscount Everything is working fine or at least seems to be- APART fromWhen there is an incoming call- The phone rings no problem- But the caller receives no ringtone.When you dial the number...
Hello,I have the problem with modulation of transmitted tones.To communication with two device I use the CONTACT ID communication protocol.When I use SPA112 the devices cannot connected.The problem is in modulating DTMF signals.Sending DTMF signal fr...
Hi,I recently updated my Cisco 7940 using firmware P003-8-12-00 for SIP including the SIPDefault.cnf file with correct firmware. But after that whenever the phone boots it looks for several files which are not available. Attached here. Also if I disc...
Hello,I have a Cisco SPA 112.I have configurate one number on line 1 and another number on line 2.I have credit on both numbers to make calls and in information from configuration menu every line look registrated.When i finished the configuration of ...
My ATA is not registering with the PBX system. If I setup a softphone I can get it to register without any issues. The issue seems to be with the ATA specifically. I am running FreePBX ver 13.x (PBXinaFlash) for Raspberry Pi 2. My ATA is running ...