Voice Systems and Accessories - Small Business

Hi :I am trying to configure the SPA 112 ATA using my MAC computer Have followed all the setup steps given in the following link http://www.callcentric.com/support/device/cisco/spa112-spa122 Accept that my Service provider is freephoneline.ca (fongo)...

Dear Experts,I have a ringtone in .raw format but this file is 1222kb big -all the other files are between 5 and 20 kb.this ringtone is in stero - I know that this is wrong, but in which format I have to convert to?also my players are not supporting ...

What is the 4 digit code to change the network settings on a spa 504g phone?

Hi,I was using cisco unified configuration on uc 500 and deleted extention while phone was plugedinNow the phone does not connect and says registration failedWhat should i do i am in big problem it was my boss extentionI did same misstake with 7975 a...

Will the Cisco 521g phones work with the Cisco UC320w even if they aren't officially supported?

Hi,I need to hide the menus/ submenus in phone user interface SPA525G2:Call RecordingsMP3 PlayerWeb ApplicationsUser PreferencesNetwork ConfigurationDevice AdministrationStatusAfter  consulting the Provisioning & Admin Guides and trying to use the  P...

Dear friends ,I was using cisco unified communication assisstent on uc 500 and deleted extention while phone was pliged inNow its not registering say registration rejected some thong like thisI am freaking out its my bosses extentionPlz help me i am ...

Hi all, We have the issue on 6 units of SPA525G,experiencing the  issues with the phones locking up during a call. The display is still  lit and call appears to be active (timer) but the call is disconnected  and then do dial tone.  The only way to ...

Hi Everyone,I just thought I would share my experience with an issue setting up my SPA112 with voip.ms. Although I still do not have a solution, the Cisco technical support has been very helpful allowing us to track down and debug the issue.Hardware:...

I have a Cisco 521 that is connected to a UC520 system. When the phone boots, it says initializing network, and successfully gets an IP via DHCP, but then phone just shows an X on the screen. Can anyone please help me troubleshoot this means? Thanks!

Hello, we have a UC560 with 106 user licenses that we want to return the configuration to factory default in order to correct some configuration mis-haps.Will we have an issue with returning the user licenses to the UC after resetting it?Please advis...

Hi, i have a few SPA509G phones and i've created a queue in my asterisk and when i try to logon on i press 123* and e get a busy tone saying invalid numer...this is the original dial plan:(*xx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-9]xxxxxxS0|xxxxxxxxxxxx....