Voice Systems and Accessories - Small Business

Just wanted to confirm before purchasing how the UC560 handles PSTN Analog lines.  We have 8 analog lines each with a different number.. example 123-456-7899, 123-456-7898, 123-456-7897 etc....If the office wants to use one of the numbers as the "mai...

I have recently upgraded my WRP400 with the latest firmware (2.00.26) and found that the DDNS updating function with dyndns.org is stopped.I made tests with the previous firmwares (2.00.20 and even with the old 1.01.00) and DDNS updating works with t...

Still confused about night service code.Floating Extension 157. SIP DID points to 157. CfwdAll - Blast group for a bunch of phones (during the day). Night service call forward all points to a different blast group (during the night). Night service co...

Another bug to report:On a CiscoIPPhoneExecute POST, if you pass a URL with multiple parameters, only the first parameter is collected. I was forced to bundle all my parameters into one and pull them all out again.Syslog excerpt:Jul 12 22:13:12 172.1...

Seems like noone uses XML on these phones as I have found a number of bugs as follows:1) The Header Refresh MUST have a URL specified. This is optional in the standard2) Sending a Softkey Cancel in a CiscoIPPhoneExecute crashes the phone. request reb...

i am trying to  configuredqsic trunk between cme and panasonic pbx.but the controller is down.here is the show command.cme#show controllers e1E1 0/2/0 is down.  Applique type is Channelized E1 - balanced  Transmitter is sending remote alarm.  Receive...

Using newest firmware 1.2.1 , anyone else having this problem ?  If i set the jitter level to medium +  and try calling out it works fine. If i set No to use jitter and have it set to low, same thing. is this a bug or am i misunderstadning how jitter...

Does anyone know how long it should take to add around 70 users/phone via the spreadhseet upload? It's been around 45 minutes so far...

Help, please.I've just deployed a UC560 with SPA502's and 525g's, the 502 are registering fine and getting the correct ip address.  The 525's are also getting the correct ip address, however they are not getting any configuration.  I've checked and r...

Hi, I wanted if possible to configure BLF for SPA 502G phone. It is configured with SPCP signaling protocol. I cannot change anything in webadmin page and I think that is because I use SPCP so I need to configure it in ephone-dn. Can someone help me ...

Hello there.  I ran into an interesting problem.  I have this UC520 here that I wanted to update with the 8.6.0 package.  So, I let CCA go to town and to the upgrade.  However, upon final reboot, nothing was happening.  So i got into the serial inter...

can I somehow connect one of those stations to my UC 320?Thank you

Good Day,Hope someone can assist me?I have a UC 520 running software release: uc500-advipservicesk9-mz.151-2.T2, I would like to register a Cisco 3905 IP phone to the UC520 but I understand I need CME 8.8 for this to work. I have searched the whole C...

I have SIP trunking (no FXO). I realize it's not very reliable for faxing, but I still would like to give it a shot.Under Telephony > Call handling > T.37 Fax to Mail, it's enabled. Under Mailboxes it says:"Mailboxes with the extension configured as ...

I've initially added an XML template for ITSP SIP trunk provider. That template proved to be bad and I created the SIP Trunk successfully without an XML template, but now every time I open CCA the old provider template reappears in the list. How do I...