Connected to a UC540.When external calls come in to a hunt group which the SPA525 is a member of, the phone rings, then rings again very quickly. Waits for a bit, then double rings again.. etc.. On an SPA504G on the same hunt group it rings normally....
We are proposing the BE3000 solution to a customer who has 4 PRI T1's, and the MCS 7890-C1 appliance only has 2 PRI T-1 ports. We are proposing a 2901 ISR at this site to terminate the other 2 PRI T1's. Can I have two of the 4 T1's terminated on the ...
Is there a way to change the amount of recording time on a specific mailbox that someone can leave a message for? Does anyone know the default message length?Thank you-Tim
Hi all,Has anyone attempted connection of the UC320 to a door access system? is it possible and what are the connections and/or instructions?I have only FXO ports available as the fxs will be used elsewhere. I won't know what the 3rd party door syste...
Am setting up an sbs 2011 server to a uc320w. Have installed sbs fine and have had uc320 acting separately as the DHCP server with Internet connected to a test pc. Now I wish to connect the uc320 to the sbs server and have changed the topology to hav...
Hi TeamWe have configured UC320 with 6 SPA 525.There are 2 lines with line hunt... All the phones have both lines configured as shared FXO.....Situation is like this, first call comes in, pick up from any phone. second call comes in through the line...
Has anyone managed to successfully get Polycom phones or any other sip phones to work on the UC320w?
HiI have some software I need to use to connect to the phones that runs from my PC. As the voice vLAN is on a different subnet I am unable to route from the data LAN to the voce VLAN any suggestions.Many thanksMike
Hi All,Can I ask if there is a list of explanations for random UC320 reloads? I couldnt see anything in the manual. We have a customer who has experienced a few "SIP triggered" reloads as per the reload reason on their SPA handsets.. Id like a more d...
Hi All,I have a Basic ACD configured, however when users are transferred to this group they get a US Dial tone, with a US attendant message say "all agents are busy"I'm in the UK, so the callers hear when they're transferred to the ACD as they get th...
Please help me. When i calling from asterisk to pstn SPA answers to asterisk immediately. Can it answer only when pstn subscriber picks up the phone ? Thanks a lot.
Hi All,Hopefully a simple question with a simple answer!We have installed a UC540 for our own use.Is it possible to get callers directed to on-hold music if all the lines are busy / no answer.For example - I have a hunt group of 2 phones for receptio...
Hi AllAny help here will be really appriciated...I have 2 sites with UC560 on both ends... there is a direct LAN connecttion between the 2 sites.. A voip dail-peer route calls accross the sites.. however if you make a voip call to either sites and th...
I have the Cisco UC320W phone system and I am trying to configure our system so that when a customer calls and if we are unavailable at the time if we can configure the phone system to give the customer a prompt to either go back to the main menu or ...
I hope that I posted in correct forum section.My setup and what I almost ordered today.4x POTS (tel lines)toCisco Small Business UC320W-FXO-K9 Unified Communications 320W with 4 FXO portstoCisco Small Business SG300-28P (SRW2024P-K9-NA) 28-port Gigab...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: