Voice Systems and Accessories - Small Business

I'm having a problem where people are checking their voicemail and sometimes it'snot accepting their PIN from the Cisco phone.  I've had people try a number of times without being able to log in, others can get in on the first or second try. Calling ...

Hi all,maybe somebody can help me. I installed a UC320W. Only a SIP Trunk is used as line.Everything works fine except CLIDIf you call outside, on the called phone only the no. without ext. is showed.SIP provider checked his logfiles - he receives on...

The 10-users will have a mix of SPA phones.What is needed to get the remote site to be part of the 560 so that the phones register withit?I am only looking for the hardware and taking into consideration no local PSTN at the remote site.Would I supply...

Hi guys, I have been searching all over the site and I cannot find the location or any documents on how to change the languages of the 7942 and 7965 when the phones are running in SIP mode and not controlled by the CCM.I have found information regard...

Hi!I have discovered, that there are no SPA telephones under the "load" command in "Telephony-service" section.There are only 6xxx and 7xxx types.Is there any way to configure SPA telephones in CME 9.0? Or this is only IOS question?Regards,Aleksei

Hello,I  have working setup with one SPA500S attendant console attached to  SPA504G phone. Now I need attach second set of SPA504G+SPA500S to  SPA9000 and it is not working.The  problem is, that appearance leds on SPA500S are flapping. Only one  SPA5...

Is there a guide, a how-to for connecting a Linksys SPA3102 with a Call Manager 7.x somewhere?I'm connected to LINE 1 set to port 5060Have been able to registered to call manager as a third party sip phone, can receive calls on the analog phone conne...

Good morning,we are using Asterisk and SPA3102 to connect a PSTN line.Our PSTN number is 123.We wish to call an internal "xxx" number (SPA send an INVITE to xxx), calling 123xxx from another PSTN phone.We cannot send an invite to "xxx" directly, but ...

Can i setup 2 UC500 system on different location using VPN  & sharing only 1 PSTN or ISDN connection on both side? how?Regards,Angelo

Hi Ive got the same problem as this guy, but im using the spa525g2 on the uc320whttps://supportforums.cisco.com/thread/2123038Im on 2.1.4 but ive noticed that the firmware is 7.4.8, is there a way to change this to the new firmware 7.8.9c to fix the ...

I need to have a voice mailbox for the following scenario, but I just cannot figure out how to set one up:At night calls go to the ClosedHours prompt where they are told that the company is closed and to leave a message (during the day I have a tree ...

Hi,I am using a device that acts as a door speaker system with 'ab' interface. It works quite well, but as the phone inside the house is hung up, the busy tone is received by the device but not detected. So the device didn't hung up.The company tells...