Hallo Guys, is it possible to sync the call status from Cisco IP Phone with Skype for Business. Why I'm asking. When you are calling with the IP Phone your Skype status is green as available he didn't change to call as busy. How it's possible chang...
Forum Posts
HelloI am trying to set up some SPA8800 VGWs to have calls come in on the FXO ports make a SIP call to a primary VGW and if that VGW is not available then hunt, or make another SIP call to a second VGW. I have the first SIP call working in Dial Plan...
I would like to use x2 SPA 122 and connect them point to point with a single cable to function as an intercom hotline between the line 1 on both.
Anyone know how to provision phones on a BE4000 so that each phone has soft keys for "Line 1" and "Line 2", where Lines 1+2 are PSTN lines coming into the FXO card on the BE4K? Setup is that every phone/extension wants to have have both lines availab...
Hello, I am currently operating 10x SPA525G2 with an UC540W-BRI-K9 in my company. Since this machine is not supported anymore and could not run the attached expansion-modules (SPA500DS) properly, I wanted to ask if there is a pbx which can run thos...
Resolved! IP Phone SPA504G - people can't hear me
Hi there - this relates to my work phone. Can anyone tell me how to make my voice sound louder on the phone as I have to literally shout into it? I can turn up the volume but it just makes the handset unbearably loud. Any help gratefully received, th...
Im trying to access to configuration webpage but cant get the device to optain an ip address. Device is connected directly to the router which hands out ip addresses. Device power is flashing which i believe means its trying to get an ip address?...
SPA509G 7.6.2c First off I have setup 100+ SPA5XX phones so I am familiar with the setup procedures. I use a SPA509G as I do a considerable amount of testing with our PBX servers and the many lines make it much easier. I cannot seem to reg...
FW Version 1.4.1SR1 (002) VOIP.ms technical support has recommended contacting CISCO as my SPA122 continually fails and denies incoming calls from ringing on the (2) Phone 1 and Phone 2 ports. The only remedy that seems to work is restoring the bac...
Hello community, this is my first question concerning Cisco devices so please bear with me while I try to explain the problem and everything that I think is relevant. Problem: The Call Forward does neither work on All Dest nor No Ans Dest. Symp...
Hi, I've tried to configure without success a SPA 122 in order to convert VOIP to PSTN for a fax first. I've found several tutorials and followed every steps but it didn't work. I've realized that when i was filling the quick setup page and then subm...
I have a remote SPA504G (7.4.8a) that sits behind my home router/firewall that up to this point has worked perfectly. Yesterday the unit went to orange lights on all the lines and I haven't been able to find out what happened. Neither the VOIP serve...
I have two spa8800 and two panasonic TDA600 and each TDA600 has 4 lines in two different sites, two different sites connected together using VPN, how connect spa8800 together by using local network, each line has 4 digit number.
For the experts on this forum this might be a too easy question: I would like two connect two cisco spa 301 ip phones with one cisco sg300 switch between both. Just to be able to make phone calls from one ip phone to the other, nothing else. Which si...
Hi Netmetix Long shot, did you manage to solve the problem? Currently in a similar position with BT and can't get any information. We have the following config: interface BRI0/1/0:0 no ip address isdn switch-type basic-net3 isdn overlap-receiving ...