Hi there, I purchased some used SPA50x off of eBay and am unable to get them to do anything other than display Downloading When plugged in they do the usual Initialize Network and then display Downloading of the following files SEP_mac_address_.cnf.x...
I have a brand new spa122 ATA I have setup all IP and network elements all connected ok . I have configured sip to teh proxy and I can see sip packets going back and forth although device dies not look "registered " . Problem i hav eis ai have a ba...
Hello there, i know the use of Linksys PAP2T devices but somewhere i've read that i can transfer landline (through lan) with someway... Is it possible and how ? Thanks in advance
Hi, so our brand new and shiny BE6KS just arrived, and I'm going to set it up the next couple of days. I already have some lab experience with a CUCM - however in our production environment we are migrating from a UC560. I went through the available...
Press 0 on UC540 does not transfer calls to operator. This affects some users not all.So for some users when the voicemail comes on i press 0 and transfers to the receptionist. Others press 0 and it goes nowhere.
I need a cicso tech that can help log in to my phone system, look at the logs and tell me what is wrong. Phone support is gone now and i need help. Is this possible
Is all that is on the display. Solutions?
When I answer a call on my bluetooth headset connected to the SPA525G2 ip phone and put the call on hold either using the hold button under the display or the "Hand" button, and then use the same buttons to resume the call, the audio always jumps ...
Hello and Thanks in advance using spa504g phones with spa500s side car; I want to have the side-car work as per article http://sbkb.cisco.com/CiscoSB/ukp.aspx?vw=1&docid=7aa7fdd7d543437ab12a3dbb0940aebe_Configure_Attendent_Console_Key_LED_Pattern_on...
Hi, How can I block users to lower ringtone volume. Thanks,
Hello! I'd like to know if there's any way to use the MWI or the extensions' leds for indicating missed calls? The default missed call reminder is not that noticeable, needless to say if the screensaver is on, I can't see it. Thanks!
I have a UC520 which I'm trying to configure. We are switching to a new ISP who requires that the WAN (FE 0/0) port be tagged with VLAN 35 and then the PPPOE dialer (Dialer2) connected to VLAN35. How should I go about setting this up. Thanks!
I have been trying to upgrade my cisco spa 504g iphone firmware from 7.5.7 to 7.6.2. I have been following all the steps in the upgrade process by doing it the TFTP server. The phone seems to be upgrading, but after the process is done the phone is s...
Does anyone have suggestions for configuring a line on this 8 port ATA for faxing? I have quite a few that can either send or receive and some that won't do anything. I use 4 ports for phones and 1 port for faxing (Ricoh)......any suggestions/advic...
Hello, I have a Cisco IP Spa504G phone in our upstairs conference room. I am trying to find a way to make it possible to answer a phone call come into a different line on this phone in our conference room. Or make both lines the same. Any ideas? Th...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: