Voice Systems and Accessories - Small Business

Hello,i have some problems with cisco 7921 G Wireless phones, the sounds makes some cut sounds when i am online. What is the last firmware for this phone? Or maybe you have some issue with sounds problems?Regards, FabienUC 540W FXO  Software pack 8.0...

Hi there.I've been setting up a system using 6xSPA942, 5xSPA8000 and 1xSPA8800. There is no actual VOIP outgoing or incoming. This is essentially a stand-alone training system, however I do need for people to be ableto dial out using the FXO lines on...

I have a UC540 running an eval license.  I installed two 8 user licenses but they show inactive.  I want to use those license since the eval is about to expire.  Any ideas?

Hello Community,is there a way how i can start remotely a call on my Cisco SPA phone.Example, i have a phone number i found in the internet.Now i like to launch a http command  like the reprovisioning link (http://10.172.0.153/admin/resync?http://10....

How do i go about setting the Caller ID information for Outgoing Calls. The SIP Trunk provider claims it is something I set, however with other voip provider they used to set it for me. Any help would be appreciated.

HiIs there anyway to reroute an outgoing call through another fxo port in the spa400 if the line is already being used?thanks

I've got an easily reproducable problem with call waiting on a WRP400. Here's the scenario:A (voip user) calls B (WRP400). B answers and establishes a call.C (voip user) calls B. Call waiting notifies B of the call. B hangs up with A and takes the ca...

I have aprox. 20 phones on a UC540 and only two of them are giving me a fit.  Here is what's going on for example.Ext.      300.  When I call this extension it will be BUSY 6 out of 10 times      when I call it.  The user is not on the phone, nothing...

Hi CommunityWill Smart CallConnector be avaible in a Danish language in the future??.

Hello Community,i am looking for the language files for the SPA 50XG phones.Only could find for 525 and LinkSys 900 but no for my 504 509 etc...Does someone have them?Thanks

We are starting to deploy some of these phones behind IPitomy (Asterisk) systems.  I have a couple of questions about configuring them.1.  I have entered my Multicast address 224.168.168.168:6535 into the phone, I update the config, and when I dial t...

The configuration on these phones (fw 7.4.3) is provisioned via TFTP and HTTP, and it is refreshed periodically on hourly basis (default behaviour).At each refresh the phones reboot, even if the configuration has not changed. How can avoid this behav...

Hi,I am getting frequent reboots on PAP2-NA with reboot reason code H736c003dFirmware upgrade (3.1.23) and factory reset did not helpWhat does that reason mean? Any way to solve the problem by myself?