We are installing an UC540 at a client here in Denmark, and we are unable to get the ISDN BRI lines to make outgoing calls.According to the CCA everything should be OK.Can anyone help with a correct ISDN BRI setup for Denmark?Best regardsPaal Hanson
Hello,A client in Greece uses tellas as PSTN provider.Tellas doesn't use the usual cp tone GR, as far as I understand, because ip-phones ring for about 60s after call is not answered and hang up by the call-in party.Any help to configure FXO ports to...
If the ASA5505 sits in front and manages the data vlan and the UC manages the voice do I need to just manually set the settings in network VPN for the firewall. I'm clueless and can't find much documentation on how it works.I believe option 150 will ...
Does anyone have this working? I have my SPA500S console attached to my SPA509G phone. The UC520 sees the phone perfectly but does not see the extra buttons on the console.Any thoughts on where to begin?Ryan
I can make calls with the 7936 Conference phone but I cannot enter keys during the call. eg if I dial the Voicemail, the Attendant answers but I cannot enter my passord. Is this a known problem with the 7936 on the UC520 or do I have a faulty 7936?
I need to change the IP address on the CUE module because the IP address conflicts with an internal range, but doesn't seem to be working for me. Via the CLI, I changed the Loopback 0 IP address, then on the integrated service engine I removed the d...
The box is a UC520.When trying to access CUE, I get the following error messageBuffer I/O error on device hda1, logical block 201683.There are 7 of these lines.I opened a TAC ticket for a replacement.Just curious, is this a defective CUE flash card?
Some confussion around integrated messaging vs unified messaging. Can I delete VM from outlook and phone at the same time. Meaning, single click delete on outlook also delete the VM on the phone?
Hi all,Need some advice on the outcome. Currently there is an ASA5505 managing the data network via a single subnet. Servers are plugged directly in and the switch serving the workstations is plugged in. All devices are on the 192.168.20.0 network. I...
I have UC540's proposed for a 3 site for deployment (sites A, B, and C) I was able to gain some information from: https://supportforums.cisco.com/docs/DOC-9775 However, this is very limited in its explanation of the integration of voicemail in multis...
Hi,I have a SPA525G registering to an 1861 ISR router in SIP mode. The 1861 ISR Router is also running CME and provides the standard CME local directory in XML format.I want to configure access to the XML directory from the "Directory" Button on the ...
hello, I auito, I bought an SPA3102 and I want to configure it as follows: include an internal analog of my corporate PBX SPA3102 in turning the line into my voip I wish I could configure my home 3cxphone or similar in my PC so that you can use my in...
Our office is configured with C7931G phones connected our UC520, which all works well. We also utilize the IP Communicator soft phone via IPSec VPN when working away from the office.I've been able to successfully use IP Communicator via the VPN, how...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: