Voice Systems and Accessories - Small Business

In everything I've read, it say the spa112 should have 48v in on-hook status. Mine only has 44.8 which will work with some phones and equipment but not all. If I test the ATT line I am replacing it has 48v exactly on it. I've read where there are acc...

Hi ! We face RTP connection problems, reported by the SPA8000 to a syslog daemon, when operating the SPA 8000 at a local PBX. It's even the case with internal calls, where NAT does not come into account. SPA 8000 Ethernet (WAN) port is connected to t...

I have a new SPA112 analog-voip adapter to integrate my analog phone to my VOIP phone system.  here are the two issues I want to solve. 1. I am using this dial up for my phone system which is using 4 digits extension.  I can make a street call but w...

Hi there, I have a SIP account configured on a SPA508G phone with my provider internet.lu. Unfortunately it only takes 3 rings and the calls go to the voice mail. Is there a parameter on the phone that allows me to adjust the number of rings? The pr...

Which OID do I need to use to check the SIP registration with SNMP?

The answer machine CASIO phonemate 3700 can never be triggled by SPA122 ATA adapter. 

Hello; I have a new SPA112 analog-voip adapter to integrate my analog phone to my VOIP phone system.  I assign an extension 5xxx to this adapter and it can make call to my other local phone which is extension number 1xxx.  We have a conference syste...

I am trying to configure SPA232D G1 and SPA302D G1 232 registered successful but 302 not done.   I am facing  difficulty to register handset with base   I see software version on handset shows 2.5 and base 1.36 Please advice the solution 

Hi, I would like to use the "Dial" button when looking at my missed call on the Call History but somehow all numbers has a "+1" in front of the 10 digits phone number. All of them are in my local area codes. I tried to modify the Dial plan but withou...

Trying to setup a SPA122 to use line two in CUCM9.1 Have tried the MACo ffset like a ATA186, registration fails. What is the trick to getting the second line on a SPA122 to register with CM? Line 1 works fine, have tried adding second line to device,...

Dear community I've tried automatic call forwarding on a SPA-232D. Unfortunately it does not work. Whatever I try, there's always a voice, that the number is not valid (if I call the number on where I have set up the call forwarding). I'm starting t...

Settings on How to connect a SPA112 to a Mitel 3300 as a SIP device

Hi, I would like to use the "Dial" button when looking at my missed call on the Call History but somehow all numbers has a "+1" in front of the 10 digits phone number. All of them are in my local area codes. I tried to modify the Dial plan but withou...

Hello all,I am trying to make my TV receiver (a Bell Expressvu 9242) display caller ID but it just displays garbage or does not display anything.Also, the receiver will at time reboot when a call comes in.Anyone had tried to hook a TV receiver (ideal...

Hi, Does anyone know if there is a way to enable or implement a watchdog (ie ping) mechanism in the SPA 112/122 line of products ? Essentially, I would like to trigger an ATA reboot after X minutes if the connection to the ISP goes bad. Under certai...