cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
331
Views
0
Helpful
0
Replies

CAS configuration on UC560

tmwestbr
Cisco Employee
Cisco Employee

We are working with Mediacom to connect via T1-CAS to an IAD2432 (E&M-wink-start).  Is there a recommended configuration for this? Below is the snippet of the T1 controller config from the UC560:

!

controller T1 0/3/0

fdl ansi

cablelength short 133

ds0-group 3 timeslots 1-24 type e&m-wink-start

The IAD is configured with:

controller T1 1/0

mode cas

clock source internal

cablelength short 133

ds0-group 0 timeslots 1-24 type e&m-wink-start

!

Also, they’re asking about a 2-wire versus a 4-wire configuration. Does the UC500 require/ work better with one or the other?

Thank you for your time.

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers