I hope that I posted in correct forum section.
My setup and what I almost ordered today.
4x POTS (tel lines)
to
Cisco Small Business UC320W-FXO-K9 Unified Communications 320W with 4 FXO ports
to
Cisco Small Business SG300-28P (SRW2024P-K9-NA) 28-port Gigabit PoE Managed Switch
to
x4 - Cisco SPA501 SIP 8 Line IP Phone With PoE and PC Port SPA501
and
x2 - CISCO SPA514G SIP 4 Line IP Phone+Dsply PoE Gig PC SPA514G
I planned to use this in my office for my voice and data needs.
Questions:
1. Two USB ports for Cisco Small Business UC320W are listed but (still) not availble? (Future use?)
- I planned to use 3g internet service for internet backup via 3G_USB modem.
- If no usb ports are availble, any workaround for 3g_modem is availble without changing the UC320?
2. Do I need to buy additional licences for using the listed hardware out of the box?
Thank you,
K
UPDATE: (due to "Cisco confidential" the link has been removed)
Q: What are the USB ports on the Cisco UC300 Series used for?
A. The USB ports are used for backup of configuration and voicemail; 3G backup will be supported in a
future release.
Q: (When is the "future" ? )
Message was edited by:
Cindy Toy
Cisco Small Business Community Manager
for Cisco Small Business Products
www.cisco.com/go/smallbizsupport
;
twitter: CiscoSBsupport
