01-21-2015 03:00 AM - edited 03-21-2019 08:30 AM
We use the UC320 phone system and a couple of SPA525G phones. The phone software and the menu give a couple of options to suppress our caller ID in specific outbound calls, but neither does work. Our number is shown to the recipient all the time.
Any hint or advise on how to actually make a per call CLID work? That would be awesome.
Thanks a lot!
Andreas
01-21-2015 06:44 AM
If the phone software gives u an option to suppress caller id in specific outbound, and is not working then there must a problem either from your initial configuration ..Have you checked and confirm your configuration?please do that and then we can go into detail in solving your issue
01-21-2015 08:31 AM
Our technician says there's not so much we could do different in the basic / initial configuration. Still, within the user preferences (7), I can go to call preferences (1) and scroll down (six steps) to suppress Call-ID. However, I can't move the the switch left or right. It's there but it can't be activated.
The other option was through a pre-dial code (**63# or so).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: