cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3634
Views
0
Helpful
1
Replies

Linksys SPA942 Firmware Not Updating

kevin
Beginner
Beginner

I am trying to install the 6.1.5 firmware on my IP phones, but it keeps coming back with "Upgrade Failed: No Response from SPA". I unzip the file to my desktop, run the exe and put in the IP address of the phone, but I keep getting the error.

If you put the IP address in the address bar, the phone comes up no problem. I can easily make changes through the web interface, and the phone will reboot, but I can not upgrade the firmware. Is there any other way I can do this? Any reason why this might be happening?

1 Reply 1

nseto
Frequent Contributor
Frequent Contributor

Check two things

1.  The 'Upgrade Enable' is set to yes.  Located in Provisioning/Firmware upgrade.

2.  Check that the upgrade request reaches the phone, you can check this via a ethereal trace.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers