cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
391
Views
0
Helpful
2
Replies

Sunday 2:00AM DST change and default maintenance times.

akbriancoop
Level 1
Level 1

Edit to add: This is in regards to the UC320W with most recent firmware.

A timely question. In most of the USA the change to daylight savings  time occurs at 2:00AM Sunday morning. At 2:00AM it will become 3:00AM  DST. If  "use daylight savings?" and "enable USB backup?" are checked  and left at default values, and scheduled maintenance is left at it's  default value, it is unclear if a problem will occur. The default time  for a scheduled backup to a USB is 2:00 AM Sunday, and the default  reboot time is 3:00AM Sunday.  Do I need to change the scheduled times  before this weekend? Or does it somehow work anyway? Thank You.

2 Replies 2

wenyang
Level 4
Level 4

Hi Brian,

Please move the system backup time and reboot time to 3:00AM and 4:00AM, and apply configure to make them effective.

Best regards,

Wendy

Thank you for the prompt response. Just a suggestion to your developers. Perhaps in the future the default values for backup could be 3:15am, and 3:30am for reboot, with the minute values hard coded in the manner as they are currently at xx:00 xx. This would preclude event conflict. Thanks again.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: