Anyconnect Wizard Not working.

[Conrad Gotzmann]

Local ASA lan = 192.168.7.X

Anyconnect IP-Pool =  192.168.8.100 - 192.168.8.110/255.255.255.0

Exempt VPN traffic selected. 

select inside interface and local network any4

This processes  fine, creates all the settings, but when the anyconnect client connects the PC cannot access anything.

No internet , No local lan access.

If I make the IP-address pool the same as the local lan ip-range. It works.

eg: IP-pool for VPN is 192.168.7.200-192.168.7.210.

The wizard seems to be missing some steps to properly NAT / route the VPN ip pool  to the local lan

[balaji.bandi]

what is the version of ASA ?

Personally, I have used that wizard long back..sure there are some config missing parts of the wizard

you need to create an ACL for a split tunnel

same interface traffic allowed

and NAT confg

show run - post here to help or you can add as suggested above.

[MHM Cisco World]

we could not know I want to see ASA CLI config